Steps
1. Align the screw holes on the power-button with the screw holes on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x3) that secure power-button to the palm-rest and keyboard assembly.
Next steps
1. Install the I/O board.
2. Install the display assembly.
3. Install the fan.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
Removing the power-button with fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the heat sink.
4. Remove the fan.
5. Remove the display assembly.
6. Remove the I/O board.
About this task
NOTE: This procedure is applicable only for computers that are shipped with a fingerprint reader on the power-button.
The following image indicates the location of the power-button with fingerprint reader and provides a visual representation of
the removal procedure.
Removing and installing components
47
To Next Page
Loading...
