Steps
1. Remove the five screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
2. Loosen the two captive screws that secure the base cover to the palm-rest and keyboard assembly.
3. Using a plastic scribe, pry the base cover from the hinge area and continue prying on all its sides to loosen the base cover.
4. Lift the base cover off the palm-rest and keyboard assembly.
5. Disconnect the battery cable from its connector on the system board.
Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
38
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
