Steps
1. Peel the adhesive tape that secures the battery cable to the battery.
2. Remove the battery cable from the routing guides on the battery.
3. Slide down the latch on the battery-cable connector to disconnect it from the battery.
Installing the battery cable
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery cable and provides a visual representation of the installation procedure.
Steps
1. Slide the latch upwards to secure the battery cable to its connector on the battery.
2. Route the battery cable through the routing guides on the battery.
3. Adhere the tape that secures the battery cable to the battery.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
54
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
