180 Adding and Replacing Parts
Internal Card With Bluetooth
®
Wireless
Technology
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery
from the battery bay before you begin working inside the computer.
If you ordered a card with Bluetooth wireless technology with your computer,
it is already installed.
Removing the Card
1
Follow the procedures in "Before You Begin" on page 153.
2
Remove the hinge cover (see "Hinge Cover" on page 160).
3
Disconnect the cable on the card.
4
Grasp the connector end of the card and slide it out from under the
securing tabs.
1 securing tab 2 card
3 securing tab 4 cable
1
4
2
3
To Next Page
Loading...
