Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0/#1
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Secured to Screw type Quantity Screw image
Base cover Palm-rest and keyboard
assembly
M2x4 7
Base cover Palm-rest and keyboard
assembly
M2x8.5 (captive) 2
Battery Palm-rest and keyboard
assembly
M2x3 5
Solid-state drive Palm-rest and keyboard
assembly
M2x3 1 per solid-state
drive
Left fan Palm-rest and keyboard
assembly
M2x4 5
Right fan Palm-rest and keyboard
assembly
M2x5
M2x4
2
Wireless card System board M2x3 1
Touchpad Palm-rest and keyboard
assembly
M2x2 2
Touchpad bracket Palm-rest and keyboard
assembly
M2x2 2
3
Removing and installing components 11
To Next Page
Loading...
