Steps
1. Remove the three screws (M2.5x5) that secures the right-display hinge to the system board.
2. Pry open the right-display hinge at an angle of 90 degrees.
3. Peel the tape that covers the power-adapter port connector on the system board.
4. Disconnect the power-adapter port from the system board.
5. Peel the tapes that secure the power-adapter port cable to the palm-rest and keyboard assembly.
6. Remove the power-adapter port cable from the routing guides on the palm-rest and keyboard assembly.
7. Remove the power-adapter port from the palm-rest and keyboard assembly.
Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the power-adapter port and provides a visual representation of the installation
procedure.
44
Removing and installing components
To Next Page
Loading...
