Steps
1. Place and snap the base cover into place on the palm-rest and keyboard assembly.
2. Tighten the two captive screws (M2x8.5) that secure the base cover to the palm-rest and keyboard assembly.
3. Replace the seven screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
Next steps
1. Exit Service Mode.
2. Follow the procedure in After working inside your computer.
Memory module
Removing the memory
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
About this task
The following image(s) indicate the location of the memory and provides a visual representation of the removal procedure.
16
Removing and installing components
To Next Page
Loading...
