Steps
1. Place the heat-sink on the system board.
2. Align the screw holes on the heat sink to the screw holes on the system board.
3. In sequential order (1>2>3>4>5>6>7) tighten the seven captive screws that secure the heat sink to the system board.
NOTE: The number of screws on the heat sink varies depending on the graphic card configuration ordered.
Next steps
1. Install the base cover.
2. Exit Service Mode.
3. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
4. Remove the left fan.
5. Remove the heat sink.
About this task
The following image(s) indicate the location of the power-adapter port and provides a visual representation of the removal
procedure.
Removing and installing components
43
To Next Page
Loading...
