Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the
installation procedure.
Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest
and keyboard assembly.
Next steps
1. Install the speakers.
2. Install the system board.
3. Install the left fan.
4. Install the right fan.
5. Install the power button or power button with fingerprint, whichever applicable.
6. Install the power-button board.
7. Install the display assembly.
8. Install the touchpad.
9. Install the IO board.
10. Install the power-adapter port.
11. Install the battery.
12. Install the wireless card.
13. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive into M.2 slot one, whichever applicable.
14. Install the M.2 2230 solid-state drive into M.2 slot two.
15. Install the base cover.
16. Follow the procedure in After working inside your computer.
Removing and installing components
59
To Next Page
Loading...
