Steps
1. Disconnect the battery cable from the system board.
2. Remove the four screws (M2x3.5) that secure the battery to the palm-rest and keyboard assembly.
3. Lift the battery off the palm-rest and keyboard assembly.
Installing the 4-cell battery (64 Wh)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the 4-cell battery (64 Wh) and provides a visual representation of the installation
procedure.
18
Removing and installing components
To Next Page
Loading...
