Steps
1. Remove the two screws (M2.5x5) and the screw (M2x4) that secure the left display hinge to the palm-rest and keyboard
assembly.
2. Pry open the left display hinge to an angle of 90 degrees.
3. Peel the tape that secures the I/O-board connector latch to the I/O board.
4. Lift the I/O-board cable-connector latch and disconnect the I/O-board cable from the I/O board.
5. Disconnect the coin-cell battery cable from the I/O board.
6. Lift the latch and disconnect the power-button board cable from the I/O board.
7. Remove the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
8. Lift the I/O board off the palm-rest and keyboard assembly.
Installing the I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the I/O board and provides a visual representation of the installation procedure.
32
Removing and installing components
To Next Page
Loading...
