Installing the heat sink (UMA)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: This procedure applies only to computers shipped with an UMA graphics processor.
The following image(s) indicate the location of the heat sink (UMA) and provides a visual representation of the installation
procedure.
Steps
1. Place the heat sink on the system board.
2. Align the screw holes on the heat sink with the screw holes on the system board.
3. In sequential order (1 > 2 > 3 > 4) tighten the four captive screws that secure the heat sink to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the heat sink (discrete)
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image(s) indicate the location of the heat sink (discrete) and provides a visual representation of the removal
procedure.
Removing and installing components
39
To Next Page
Loading...
