2. Align the screw holes on the power-button board with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x3) that secure the power-button board to the palm-rest and keyboard assembly.
4. Connect the power-button board cable to the I/O board and close the latch.
5. Connect the fingerprint-reader cable to the power-button board and close the latch.
6. Close the left display hinge.
7. Align the screw holes on the left display hinge with the screw holes on the palm-rest and keyboard assembly.
8. Replace the two screws (M2.5x5) and the screw (M2x4) that secure the left display hinge to the palm-rest and keyboard
assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Speaker board
Removing the speaker board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image(s) indicate the location of the speaker board and provides a visual representation of the removal procedure.
Steps
1. Disconnect the display-speaker cable from the speaker board.
2. Using the pull tab, disconnect the speaker-board cable from the speaker board.
3. Remove the two screws (M2x1.8) that secure the speaker board to the palm-rest and keyboard assembly.
4. Lift the speaker board off the palm-rest and keyboard assembly.
46
Removing and installing components
To Next Page
Loading...
