8. Connect the touchpad cable to the system board and close the latch.
9. Connect the speaker-board cable to the connector on the system board.
10. Connect the speaker cables to the connector on the system board.
11. Connect the I/O board cable to the connector on the system board and close the latch.
12. Connect the fan cable to the connector on the system board.
Next steps
1. Install the heat sink (UMA) or the heat sink (discrete), whichever is applicable.
2. Install the fan.
3. Install the display assembly.
4. Install the wireless card.
5. Install the M.2 2280 solid-state drive or the M.2 2230 solid-state drive, whichever is applicable.
6. Install the 4-cell battery (64 Wh) or the 6-cell battery (86 Wh), whichever is applicable.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 4-cell battery (64 Wh) or the 6-cell battery (86 Wh), whichever is applicable.
About this task
The following image(s) indicate the location of the touchpad and provides a visual representation of the removal procedure.
54
Removing and installing components
To Next Page
Loading...
