Replacing the Back Cover
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Replace the control-buttons board.
2 Slide the hard-drive cable into the slot on the back cover.
3 Connect the battery cable to the system board.
4 Carefully turn the back cover over and align the tabs on the back cover
with the slots on the display bezel.
5 Snap the back cover into place.
6 Replace the screws that secure the back cover to the display bezel.
Post-requisites
Follow the procedure from step 7 to step 12 in “Replacing the Hard Drive”.
24
To Next Page
Loading...
