Replacing the Control-Buttons
Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the control-buttons board with the screw holes
on the back cover.
2 Replace the screws that secure the control-buttons board to the back
cover.
3 Connect the control-buttons board cable to the control-buttons board
and secure it with the tape.
Post-requisites
Follow the instructions from step 3 to step 6 in “Replacing the Back Cover”.
30
To Next Page
Loading...
