Removing the Power-Status
Light Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Prerequisites
Follow the instructions from step 1 to step 7 in “Removing the Back Cover”.
Procedure
1 Lift the connector latch and disconnect the power-status light cable from
the power-status light board.
2 Peel the tape that secures the power-status light board to the display
bezel.
3 Remove the screws that secure the power status-light board to the
display bezel.
34
To Next Page
Loading...
