Replacing the drive cage
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Replace the optical drive, if applicable.
2 Replace the 2.5–inch hard drive.
or
Slide and place the 3.5 inch hard-drive assembly into the drive cage, if
installed.
3 Align the tab on the drive cage to the slot on the chassis.
4 Slide the drive cage into the chassis.
5 Replace the screws that secure the drive cage to the chassis.
6 Connect the power cables and data cables to all the drives.
NOTE: The number and type of drives varies depending on the
configuration you ordered.
Post-requisites
1 Replace the heat-sink assembly.
2 Replace the front bezel.
3 Replace the computer cover.
49
To Next Page
Loading...
