Replacing the power-button
module
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Slide the power-button cable through the slot on the chassis.
2 Align and push the power-button module into the slot on the front panel
till the clips on the module snap in place.
3 Connect the power-button cable to the system board.
Post-requisites
1 Replace the drive cage.
2 Replace the heat-sink assembly.
3 Replace the front bezel.
4 Replace the computer cover.
73
To Next Page
Loading...
