Fingerprint-reader board
Removing the fingerprint-reader board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: The fingeprint-reader board is an optional component and will only be installed in systems shipped with a fingerprint
reader.
The following images indicate the location of the fingerprint-reader board and provides a visual representation of the removal
procedure.
Steps
1. Open the latch and disconnect the power-button cable from the fingerprint-reader board.
2. Open the latch and disconnect the fingerprint-reader board cable from the fingerprint-reader board.
3. Slide and remove the fingerprint-reader board from the securing clip on the palm-rest and keyboard assembly.
Installing the fingerprint-reader board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the fingerprint-reader board and provides a visual representation of the installation
procedure.
Removing and installing components
39
To Next Page
Loading...
