11. Connect the power-adapter port cable to the system board.
Next steps
1. Install the display assembly.
2. Install the wireless card.
3. Install the heat sink.
4. Install the memory module.
5. Install the M.2 2230 solid-state drive, if applicable.
6. Install the M.2 2280 solid-state drive, if applicable.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the M.2 2230 solid-state drive, if applicable.
4. Remove the M.2 2280 solid-state drive, if applicable.
5. Remove the wireless card.
6. Remove the display assembly.
7. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
About this task
The following images indicate the location of the power-adapter port and provides a visual representation of the removal
procedure.
58
Removing and installing components
To Next Page
Loading...
