Dell Inspiron 3647 - Removing the Memory Module(s)

16 | Removing the Memory Module(s)
Removing the Memory Module(s)
WARNING: B efore working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 7. After working inside your computer, follow the instructions in
"After Working Inside Your Computer" on page 9. For more safety best practices,
see the Regulatory Compliance home page at dell.com/regulatory_compliance.
Prerequisites
1 Remove the computer cover. See "Removing the Computer Cover" on page 12.
2 Remove the fan shroud. See "Removing the Fan Shroud" on page 14.
Procedure
1 Locate the memory-module connector on the system board. See "System-Board
Components" on page 11.
2 Press out the securing clip at each end of the memory-module connector.
3 Grasp the memory module and pull it upward.
NOTE: If the memory module is difficult to remove, hold and gently pull it
upward from one end and then on the other end until the memory module is
disengaged from the connector.
1 securing clips (2) 2 memory module
3 memory-module connector
2
3
1
book.book Page 16 Monday, November 25, 2013 3:53 PM