Removing the Power-Button Module | 37
Procedure
1 Disconnect the power-button module cable from the system-board connector
(LEDH1). See "System-Board Components" on page 11.
2 Remove the power-button module cable from the routing guides on the chassis.
3 Press the power-button module tabs to release the power-button module from the
front panel.
4 Slide the power-button module along with its cable through the slot on the front
panel.
5 Set the power-button module aside.
6 Set aside the power-button module.
1 power-button cable 2 tabs
3 power-button module
book.book Page 37 Monday, November 25, 2013 3:53 PM
To Next Page
Loading...
