Steps
1. Place and slide the power supply into its slot on the chassis.
2. Route the power-supply cables into the routing guides on the chassis.
3. Connect the power-supply cables to the two connectors on the system board.
NOTE:
The power-supply cable is connected to the system board at two locations and supply power to the following
components at the two location:
• Processor
• System board
4. Replace the three screws (6-32) that secure the power supply to the chassis.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Hard drive
Removing the hard drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
About this task
The following image(s) indicate the location of the hard drive and provides a visual representation of the removal procedure.
Removing and installing components
27
To Next Page
Loading...
