Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: For computers shipped with 10th Generation Intel Core i5-10400F and 10th Generation Intel Core i7-10700F
processors a VGA-connector cover is installed over the VGA connector and must be installed after the VGA-connector
board has been installed.
NOTE: If either the processor or the fan and heat-sink assembly is replaced, use the thermal grease provided in the kit
to ensure that thermal conductivity is achieved.
The following image(s) indicate the location of the system board and provides a visual representation of the installation procedure.
44 Removing and installing components
To Next Page
Loading...
