Steps
1. Lay the computer with its right side facing down.
2. Loosen the two captive screws that secure the VGA-connector cover to the VGA connector. (if applicable)
3. Remove the VGA-connector cover from the VGA connector. (if applicable)
4. Remove the screw (6-32) that secures the I/O-cover door to the chassis.
5. Lift the pull tab and open the I/O-cover door.
6. Disconnect the following cables from the system board.
• power-supply cables
• hard-drive cable
• power-button cable
7. Remove the M.2 card-mounting screw (6-32) that secures the system board to the chassis.
NOTE:
The location of the M.2 card mounting screw will differ than what is shown in the image depending on the
type of M.2 card installed in the slot on the system board.
8. Remove the eight screws (6-32) that secure the system board to the chassis.
9. Lift the system board at an angle and remove it from the chassis.
Removing and installing components
43
To Next Page
Loading...
