3. Using the alignment posts, press the hinges down on the system board and the palm-rest and keyboard assembly.
4. Replace the six screws (M2x2.5) that secure the left and right hinges to the system board and palm-rest and keyboard
assembly.
5. Route the display cable through the routing guides on the fan and the palm-rest and keyboard assembly.
6. Slide the display cable to the connector on the system board and close the latch to secure the cable.
7. Replace the tape that secures the display-cable latch to the system board.
8. Connect the optical-drive connector board cable to the optical-drive board.
76
Replacing the power-adapter port
To Next Page
Loading...
