3 Using the alignment posts, press the hinges down on the system board and the palm-rest and keyboard assembly.
4 Replace the six screws (M2.5x5) that secure the left and right hinges to the system board and palm-rest and keyboard assembly.
5 Route the display cable through the routing guides on the fan and the palm-rest and keyboard assembly.
6 Slide the display cable to the connector on the system board and close the latch to secure the cable.
7 Replace the tape that secures the display-cable latch to the system board.
Identifier GUID-06349007-D63B-4C1D-A932-6C91AC1D6953
Status Released
Post-requisites
1 Replace the wireless card.
2 Replace the base cover.
90
Replacing the display assembly
To Next Page
Loading...
