Post-requisites
Replace the base cover.
Procedure to move the screw mount
This computer supports two solid-state drive form factors:
● M.2 2230
● M.2 2280
If you are replacing the solid-state drive of a different form factor other than the one removed, see the following procedure to
move the location of the screw mount.
1. Remove the screw mount from the palm-rest and keyboard assembly.
2. Turn the screw mount to 180 degrees.
3. Insert the screw mount into the other screw mount slot on the palm-rest and keyboard assembly.
4. Align the notch on the solid-state drive/Intel Optane memory module with the tab on the solid-state drive slot.
5. Slide the solid-state drive/Intel Optane memory module firmly into the solid-state drive slot at an angle.
6. Press the other end of the solid-state drive/Intel Optane memory module and replace the screw (M2x3) that secures the
solid-state drive to the palm-rest assembly.
26
Replacing the solid-state drive/Intel Optane
To Next Page
Loading...
