Removing the camera
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1. Remove the base cover.
2. Remove the wireless card.
3. Remove the fan.
4. Remove the heat sink.
5. Remove the display assembly.
6. Follow the procedure from step 1 to step 6 in "Removing the display panel".
Procedure
1. Using a plastic scribe, remove the camera module from the display-panel assembly.
2. Roll over the camera module.
3. Release it from the adhesive tape and disconnect the camera cable from the camera module.
40
72 Removing the camera
To Next Page
Loading...
