1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the hinge cover.
3. Remove the two M2 x 4-mm screws.
4. Pull the LED board away from its connector.
Replacing the LED Board
1. Align the two screw holes with the two mounting holes on the bottom case assembly, and press
the board into its connector.
2. Replace the two M2 x 4-mm screws.
Fan Assembly
NOTICE: Disconnect the computer and attached devices from electrical outlets and remove any
installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by periodically
touching an unpainted metal surface on the computer.
Removing the Fan Assembly
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...20ok/Inspiron/8000/8000_SERVICE_MAN/remove.htm (48 of 52)6/21/2004 1:07:33 AM
To Next Page
Loading...
