Back to Contents Page
Removing and Replacing Parts
Dell™ Inspiron™ 8000
Preparing to Work Inside the
Computer
Recommended Tools
Screw Identification
System Components
Hard Drive
Fixed Optical Drive
Media Bay Devices
Memory Modules
Mini PCI Card Assembly
Keyboard Assembly
Display and Bezel Assembly
Display Assembly Bezel and Panel
Display Latch Assembly
Microprocessor Thermal Cooling
Assembly
Microprocessor Module
Video Card
Palm Rest Assembly
Reserve Battery
System Board Assembly
Battery and Media Bay Latch
Assemblies
Battery Charger Board
LED Board
Fan Assembly
RJ-11/RJ-45 Board
Preparing to Work Inside the Computer
NOTICE: Only a certified service technician should perform repairs on your computer. Damage
or inoperability due to servicing not authorized by Dell is not covered by your warranty.
NOTICE: Unless otherwise noted, each procedure in this manual assumes that a part can be
replaced by performing the removal procedure in reverse order.
NOTICE: To avoid damaging the computer, perform the following steps before you begin
working inside the computer.
1. Make sure that the work surface is clean to prevent scratching the computer cover.
2. Save and close any open files, and exit any open programs.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...20ok/Inspiron/8000/8000_SERVICE_MAN/remove.htm (1 of 52)6/21/2004 1:07:32 AM
To Next Page
Loading...
