1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the system board.
3. Remove the three M2 x 4-mm screws from the fan assembly.
4. Disconnect the two fan cables from the system board.
5. Pull the fan assembly away from the back-panel bracket.
NOTICE: When reconnecting the fan cables, connect the shorter cable to the connector closest
to the fan assembly. Route both cables so that they will not be pinched by the thermal cooling
assembly.
RJ-11/RJ-45 Board
NOTICE: Disconnect the computer and attached devices from electrical outlets and remove any
installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by periodically
touching an unpainted metal surface on the computer.
Removing the Protective Covers From the RJ-11 and RJ-45
Connectors
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...20ok/Inspiron/8000/8000_SERVICE_MAN/remove.htm (49 of 52)6/21/2004 1:07:33 AM
To Next Page
Loading...
