1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove one or both of the plastic connector covers (one or both of the covers may be installed)
by slipping a nonmarring tool into the cutout at the top and pivoting the tool up to disengage
the inner securing tab.
To replace a connector cover, orient the cover notch-side-up and snap it into the connector cutout.
Removing the RJ-11/RJ-45 Board
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...20ok/Inspiron/8000/8000_SERVICE_MAN/remove.htm (50 of 52)6/21/2004 1:07:33 AM
To Next Page
Loading...
