1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the system board.
3. Remove the M2.5 x 4-mm screw from the RJ-11/RJ-45 board.
NOTICE: The plastic tab is fragile; pull it back only far enough to remove the board
assembly.
4. Reach into the enclosure and, while pulling the tall plastic tab away from the board assembly to
release it, lift out the assembly.
When replacing the RJ-11/RJ-45 board assembly, protect the wiring harness by routing it between the
plastic posts as shown in the following figure.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...20ok/Inspiron/8000/8000_SERVICE_MAN/remove.htm (51 of 52)6/21/2004 1:07:33 AM
To Next Page
Loading...
