NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface on the computer.
Removing the LED Board
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the
hinge cover.
3. Remove the two M2 x 4-mm screws.
4. Pull the LED board away from its connector.
Replacing the LED Board
1. Align the two screw holes with the two mounting holes on the bottom case
assembly, and press the board into its connector.
2. Replace the two M2 x 4-mm screws.
Fan Assembly
file:///F|/Service%20Manuals/Dell/Inspiron/8100/remove.htm (52 of 56) [2/28/2004 7:37:23 AM]
To Next Page
Loading...
