x:\ is not accessible. The device is not ready— Insert a disk
into the drive and try again.
A filename cannot contain any of the following characters: \
/ : * ? " < > |— Do not use these characters in filenames.
Not enough memory or resources. Close some programs and
try again— You have too many programs open. Close all windows
and open the program that you want to use.
The file being copied is too large for the destination drive—
The file that you are trying to copy is too large to fit on the disk, or
the disk is too full. Try copying the file to a different disk or use a
larger capacity disk.
A required .DLL file was not found— The program that you are
trying to open is missing an essential file. To remove and then
reinstall the program:
Windows Me:
1. Click the Start button, point to Settings, and then click
Control Panel.
2. Double-click the Add/Remove Programs icon.
3. Select the program that you want to remove.
4. Click Add/Remove and follow the prompts on the screen.
5. See the program documentation for installation instructions.
Windows 2000:
1. Click the Start button, point to Settings, and then click
Control Panel.
2. Double-click the Add/Remove Programs icon.
3. Select the program that you want to remove.
4. Click Change/Remove and follow the prompts on the
screen.
5. See the program documentation for installation instructions.
General Program Problems
file:///F|/Service%20Manuals/Dell/Inspiron/8100/solving.htm (14 of 18) [2/28/2004 7:37:14 AM]
To Next Page
Loading...
