Dell Inspiron 8100 - Page 77

Removing and Replacing Parts : Dell Inspiron 8100
NOTICE: When reinstalling a screw, you must use a screw of the correct
diameter and length. Make sure that the screw is properly aligned with its
corresponding hole, and avoid over tightening.
Screw Placemat
Hard Drive Door
Security:M3 x 5 mm (1
each)
Keyboard to Bottom
Case Assembly:M2.5 x
20 mm (4 each; plus
one in memory module
cover and one in Mini
PCI card cover)
Display to
Base:M2.5 x 6
mm (3 each; 2
at back of
computer; 1 at
flex-cable
strain relief)
file:///F|/Service%20Manuals/Dell/Inspiron/8100/remove.htm (4 of 56) [2/28/2004 7:37:23 AM]