NOTICE: When reconnecting the flex cable, press down on both ends of the
connector, not in the middle. Pressing the middle of the connector can damage
fragile components.
3. Open the display and remove the two screws (marked with a "circle D") that
secure the display assembly to the bottom case assembly.
4. With the display in an upright position, lift the display assembly from the bottom
case assembly.
Display Assembly Bezel and Panel
file:///F|/Service%20Manuals/Dell/Inspiron/8100/remove.htm (23 of 56) [2/28/2004 7:37:23 AM]
To Next Page
Loading...
