Dell Latitude 3390 2-in-1 - Hard Disk Drive (HDD)

Hard disk drive (HDD)
Removing the HDD
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the HDD:
a Disconnect the HHD cable from the connector on the system board [1].
NOTE: Ensure to pull the HDD cable by the plastic handle to avoid damage to the connector and cable.
b Release the cable adhesive tape that secures the cable to the system board.
c Remove the screw (2) that secures the HDD on the laptop system board [2].
d Lift the HDD from the system board [3].
Installing the Hard disk drive - HDD
1 Place the HDD on the placeholder and connect to the connector on the system board.
NOTE
: Ensure to stick the adhesive tape to secure the HDD cable on the system chassis.
2 Tighten the screw (2) to secure the HDD to the laptop.
3 Install the:
a battery
b base cover
4 Follow the procedure in After working inside your computer.
14
Removing and installing components