Dell Latitude 3390 2-in-1 - Memory Modules

Installing the WLAN
1 Slide and connect the WLAN card to the connector on the system board.
2 Connect the WLAN cables to the connectors on the WLAN card.
3 Place the metal bracket to secure the WLAN cables.
4 Tighten the screw to secure the WLAN card to the laptop.
5 Install the:
a battery
b base cover
6 Follow the procedure in After working inside your computer.
Memory modules
Removing the memory module
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 Peel and hold the label that protects the memory module to the laptop.
4 To remove memory module:
a Pull the retention clips away from the memory module until the memory module pops out [1].
b Pull the memory module from the memory module socket on the system board [2].
NOTE
: Ensure to lift the memory module card by an angle NOT more than 35°.
Removing and installing components 17