Installing the Input-Output board
Steps
1. Place the I/O board on the laptop.
2. Tighten the M2x3.5 screws (2) to secure the I/O board to the laptop.
3. Connect the coin cell battery and power and volume button board cables to the connector on the I/O board.
4. Connect the I/O board cable to the connector on the system board.
5. Affix the adhesive tape to secure the I/O board cable and release the copper latch.
6. Install the:
a. battery
b. base cover
7. Follow the procedure in After working inside your computer.
Removing and installing components
29
To Next Page
Loading...
