Installing the touchpad
Steps
1. Place the touchpad board on the laptop.
2. Tighten the M2x2 screws (4) to secure the touchpad to the laptop.
3. Place the metal tab over the touchpad.
4. Tighten the M2x2 screws (4) to secure the metal tab.
5. Connect the touchpad cable and keyboard daughter board cable to the connectors on the system board.
6. Install the:
a. battery
b. base cover
7. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. WLAN card
3. To release the display assembly:
a. Peel the adhesive tapes that secure the display cable and touch screen board cables [1] [2].
b. Open the latches and disconnect the display and touch screen board cables from the system board [3] [4].
32
Removing and installing components
To Next Page
Loading...
