6. Follow the procedure in After working inside your computer.
Power connector port
Removing the power connector port
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the power connector port:
a. Disconnect the power connector port cable from the connector on the system board [1].
b. Remove the M2x3 screw (1) that secures the power connector port to the laptop [2].
c. Lift the power connector port away from the laptop [3].
Installing the power connector port
Steps
1. Insert the power connector port into the slot on the laptop.
42
Removing and installing components
To Next Page
Loading...
