Dell Latitude 3390 - Installing the Palmrest

The palmrest is the last component, after removing all the components.
Installing the palmrest
Steps
1. Place the palmrest on a flat surface.
2. Install the:
a. system board
b. speakers
c. display assembly
d. power connector port
e. I/O board
f. LED board
g. heat sink
h. touchpad
i. system fan
j. coin cell battery
k. hard disk
l. WLAN card
m. memory module
n. power and volume control board
o. battery
p. base cover
3. Follow the procedure in After working inside your computer.
Removing and installing components
47