About this task
NOTE: This procedure applies only to systems shipped with a M.2 2230 solid-state drive installed.
NOTE: The M.2 card that is installed on your system depends on the configuration ordered. Supported card configurations
on the M.2 card slot are:
● M.2 2230 solid-state drive
● M.2 2280 solid-state drive
The following images indicate the location of the M.2 2230 solid-state drive and provide a visual representation of the removal
procedure.
Steps
1. Remove the screw (M2x2) to secure the M.2 2230 solid-state drive holder to the system board.
2. Lift the M.2 2230 solid-state drive holder off the palm-rest and keyboard assembly.
3. Flip the M.2 2230 solid-state drive holder and remove the single screw (M2x1.8) that secure the M.2 2230 solid-state drive
to the M.2 2230 solid-state drive holder.
4. Remove the M.2 2230 solid-state drive.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the M.2 2230 solid-state drive and provide a visual representation of the
installation procedure.
30
Removing and installing components
To Next Page
Loading...
