2. Remove the base cover.
3. Remove the display assembly.
4. Remove the display bezel.
5. Remove the display panel.
6. Remove the camera.
About this task
The following image indicates the location of the eDP cable and provide a visual representation of the removal procedure.
Steps
1. Disconnect the eDP cable from the connector on the camera module.
2. Peel the conductive tape and unroute the eDP cable to release it from adhesive and lift the eDP cable from the display back
cover.
Installing the eDP cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the eDP cable and provides a visual representation of the installation procedure.
70
Removing and installing components
To Next Page
Loading...
