Steps
Place the display back cover on a flat surface.
Next steps
1. Install the eDP cable.
2. Install the camera.
3. Install the display panel.
4. Install the display bezel.
5. Install the display assembly.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
5. Remove the wireless card.
6. Remove the thermal fan.
7. Remove the thermal heat-sink.
8. Remove the coin-cell battery.
9. Remove the display assembly.
10. Remove the I/O board.
11. Remove the power button.
Removing and installing components
73
To Next Page
Loading...
