3. Remove the battery.
4. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
5. Remove the wireless card.
6. Remove the thermal fan.
7. Remove the thermal heatsink.
8. Remove the display assembly.
About this task
The following image indicates the connectors on your system board.
Figure 1. System-board connectors
Figure 2. System-board connectors - front
1.
Display cable connector 2. DC-in port connector
3. Speaker cable connector 4. Touchpad cable connector
5. Memory module connectors 6. Battery cable connector
7. WLAN card connector 8. M.2 solid-state drive connector
9. I/O board cable connector 10. Fan cable connector
50 Removing and installing components
To Next Page
Loading...
