Steps
Place the palm-rest and keyboard assembly on a flat surface and perform the post-requisites to install the palm-rest and
keyboard assembly.
Next steps
1. Install the power-adapter port.
2. Install the system board.
NOTE:
The system board can be installed with the thermal heat-sink attached to it in order to simplify the procedure
and preserve the thermal bond between the system board and the thermal heat-sink.
3. Install the touchpad.
4. Install the speakers.
5. Install the power button .
6. Install the I/O board.
7. Install the display assembly.
8. Install the coin-cell battery.
9. Install the thermal heat-sink.
10. Install the thermal fan.
11. Install the wireless card.
12. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
13. Install the battery.
14. Install the base cover.
15. Follow the procedure in After working inside your computer.
Removing and installing components
75
To Next Page
Loading...
